Il y a nombreux façons à vous aider à réussir le test HP HP0-144. Le bon choix est l'assurance du succès. Pass4Test peut vous offrir le bon outil de formation, lequel est une documentation de qualité. La Q&A de test HP HP0-144 est recherchée par les experts selon le résumé du test réel. Donc l'outil de formation est de qualité et aussi autorisé, votre succès du test HP HP0-144 peut bien assuré. Nous allons mettre le jour successivement juste pour répondre les demandes de tous candidats.
Selon les anciens test HP HP0-144, la Q&A offerte par Pass4Test est bien liée avec le test réel.
Vous pouvez comparer un peu les Q&As dans les autres sites web que lesquelles de Pass4Test, c'est pas difficile à trouver que la Q&A HP HP0-144 est plus complète. Vous pouvez télécharger le démo gratuit à prendre un essai de la qualité de Pass4Test. La raison de la grande couverture des questions et la haute qualité des réponses vient de l'expérience riche et la connaissances professionnelles des experts de Pass4Test. La nouvelle Q&A de HP HP0-144 lancée par l'équipe de Pass4Test sont bien populaire par les candidats.
Pass4Test est un bon site d'offrir la facilité aux candidats de test HP HP0-144. Selon les anciens test, l'outil de formation HP HP0-144 est bien proche de test réel.
Votre vie changera beaucoup après d'obtenir le Certificat de HP HP0-144. Tout va améliorer, la vie, le boulot, etc. Après tout, HP HP0-144 est un test très important dans la série de test Certification HP. Mais c'est pas facile à réussir le test HP HP0-144.
Code d'Examen: HP0-144
Nom d'Examen: HP (ProCurve Secure WAN)
Questions et réponses: 111 Q&As
Le produit de Pass4Test peut assurer les candidats à réussir le test HP HP0-144 à la première fois, mais aussi offrir la mise à jour gratuite pendant un an, les clients peuvent recevoir les ressources plus nouvelles. Pass4Test n'est pas seulement un site, mais aussi un bon centre de service.
HP0-144 Démo gratuit à télécharger: http://www.pass4test.fr/HP0-144.html
NO.1 The Asymmetric Digital Subscriber Line (ADSL) keeps going into training mode. What is causing this
problem?
A. The signaling type configured for the router does not match the signaling type used by the service
provider.
B. The encapsulation type configured for the router does not match the type used by the service provider.
C. The signal-to-noise (SNR) margin configured for the router is too high.
D. The ADSL interface has not been assigned an IP address.
Answer: C
certification HP certification HP0-144 HP0-144 HP0-144
NO.2 What determines the number of Asynchronous Transfer Mode (ATM) subinterfaces you configure for
an Asymmetric Digital Subscriber Line (ADSL) connection?
A. the number of LANs you want to connect to the Internet
B. the number of access control lists (ACLs) you want to apply to the ADSL interface
C. the amount of bandwidth you want to reserve for upstream and downstream transmissions
D. the number of virtual circuits you want to establish
Answer: D
certification HP HP0-144 HP0-144 HP0-144 examen HP0-144 examen
NO.3 How many access control lists (ACLs) can you apply directly to one interface?
A. 1
B. 2
C. 5
D. unlimited number
Answer: B
certification HP HP0-144 certification HP0-144 HP0-144 examen
NO.4 Click the Exhibit button.
You want your ProCurve Secure Router to act as a gateway device for any remote VPN client who
initiates IKE in its most secure mode. Which policy shown contains the correct configurations for this
use?
A. 1
B. 2
C. 3
D. 4
E. 5
F. 6
G. 7
Answer: C
HP HP0-144 examen certification HP0-144 HP0-144 HP0-144 examen
NO.5 Before the ProCurve Secure Router and the DSL Access Multiplexer (DSLAM) exchange
Asynchronous Transfer Mode (ATM) cells, they utilize physical-layer signaling to establish an Asymmetric
DSL (ADSL) connection. Which monitor evaluates the signal-to-noise ratio (SNR) margin while the router
and the DSLAM establish the physical ADSL connection?
A. ADSL monitor
B. showtime monitor
C. phase 1 monitor
D. training monitor
Answer: D
HP HP0-144 examen HP0-144
NO.6 Which command allows you to use enable mode commands from any mode except basic mode?
A. the get command
B. the go command
C. the nomode command
D. the do command
Answer: D
certification HP certification HP0-144 certification HP0-144 HP0-144 examen certification HP0-144
NO.7 You have configured an Integrated Services Digital Network (ISDN) backup for your organization's
Frame Relay connection. When this connection goes down, which virtual interface could establish and
maintain the backup connection?
A. a backup Asynchronous Transfer Mode (ATM) interface
B. a backup Frame Relay interface
C. a backup Point-to-Point Protocol (PPP) interface
D. a backup BRI ISDN interface
Answer: C
HP examen HP0-144 HP0-144 certification HP0-144 HP0-144 examen certification HP0-144
NO.8 Which Quality of Service (QoS) features does the ProCurve Secure Router support? Select TWO.
A. custom queuing
B. low latency queuing (LLQ)
C. weighted fair queuing (WFQ)
D. generic traffic shaping (GTS)
E. Frame Relay traffic shaping (FRTS)
Answer: BC
HP certification HP0-144 HP0-144 certification HP0-144
NO.9 Which function does the virtual path identifier/virtual channel identifier (VPI/VCI) perform?
A. It identifies the endpoint for an Asynchronous Transfer Mode (ATM) connection.
B. It identifies the tunnel endpoint for virtual private network (VPN) peers.
C. It identifies the permanent virtual circuit (PVC) in a Frame Relay network.
D. It defines each peer in a Point-to-Point Protocol (PPP) connection, if authentication is configured.
Answer: A
HP certification HP0-144 HP0-144 examen
NO.10 Which type of firewall monitors traffic on several layers of the Open Systems Interconnection (OSI)
model?
A. packet-filtering firewall
B. circuit-level gateway
C. application-level gateway
D. stateful-inspection firewall
Answer: D
HP HP0-144 HP0-144 examen
NO.11 How can you configure the ProCurve Secure Router so that a backup module does not establish a
backup connection with an unauthenticated peer?
A. Set the backup call mode so that the module cannot answer calls until the primary connection goes
down.
B. Configure PAP or CHAP on the backup interface.
C. Add an authentication, authorization, and accounting (AAA) list to the backup interface.
D. Add authenticated routers' hostnames to the global configuration mode database.
Answer: B
certification HP HP0-144 certification HP0-144 HP0-144 examen
NO.12 When you are configuring an Asymmetric Digital Subscriber Line (ADSL), what is the purpose of
training mode?
A. ADSL is dependent upon line quality; ADSL devices must determine the best way to use the line.
B. ADSL devices always negotiate the signaling standard used, based on the type of DSLAM used by the
public carrier.
C. The ADSL device and the DSLAM must identify the fastest switched virtual circuit (SVC) available.
D. The training mode is essentially a testing phase to determine if the ADSL module itself is working
correctly.
Answer: A
HP examen certification HP0-144 certification HP0-144 HP0-144 certification HP0-144 HP0-144
NO.13 Which feature does the ProCurve Secure Router 7203dl provide that the ProCurve Secure Router
7102dl does not?
A. built-in encryption module
B. support for redundant power source (RPS)
C. one additional Ethernet port
D. support for up to 6 ADSL lines
Answer: B
HP HP0-144 certification HP0-144 HP0-144 HP0-144 HP0-144 examen
NO.14 Which type of connection may be used for the backup modules on the ProCurve Secure Router?
A. Asymmetric Digital Subscriber Line (ADSL)2+, Annex A or Annex B
B. T1 or E1 connections
C. Integrated Services Digital Network (ISDN) connection
D. Asynchronous Transfer Mode (ATM) connection
Answer: C
HP HP0-144 HP0-144 examen
NO.15 The status of the BRI interface is "connected." What does a connected status indicate?
A. The backup module is installed in the ProCurve Secure Router and is ready to be configured.
B. The BRI interface has been assigned to a primary connection.
C. The BRI interface is ready to provide a backup connection.
D. The BRI interface is currently providing a backup connection.
Answer: D
certification HP HP0-144 HP0-144 examen HP0-144 HP0-144 certification HP0-144
NO.16 What must you do to configure Point-to-Point Protocol over Ethernet (PPPoE) for an Asymmetric
Digital Subscriber Line (ADSL)?
A. Configure and bind the ATM interface to the ADSL interface; then bind the ATM subinterface to a PPP
interface.
B. Configure a PPP interface; then bind the PPP interface to the ADSL interface.
C. Configure both an ATM interface and a PPP interface, and bind the ADSL interface to both virtual
interfaces.
D. Configure a PPPoE interface and bind it directly to the ADSL interface.
Answer: A
HP HP0-144 certification HP0-144
NO.17 What is a disadvantage of dynamic routing?
A. Dynamic routing does not allow you to restrict which networks are included in routing tables.
B. Dynamic routing can consume bandwidth and CPU processes on the router.
C. Dynamic routing is less scalable than static routing.
D. Dynamic routing makes adding new networks to a WAN difficult.
Answer: B
certification HP HP0-144 certification HP0-144
NO.18 Which steps must you complete to enable access to the ProCurve Secure Router's web interface?
Select TWO.
A. Enable the ftp server.
B. Enable the http server.
C. Configure a Telnet password.
D. Configure an enable mode password.
E. Configure a username and password.
F. Configure an ACL permitting FTP traffic.
Answer: BE
certification HP HP0-144 HP0-144 examen certification HP0-144 HP0-144 examen
NO.19 Which tasks can you use CompactFlash to complete? Select TWO.
A. Configure routers at remote sites.
B. Increase RAM on the router by configuring virtual memory.
C. Enter bootstrap mode.
D. Back up configuration files.
E. Enable IPSec security.
F. Store and view the Secure Router OS in an uncompressed format.
Answer: AD
HP HP0-144 certification HP0-144
NO.20 Which interfaces can be configured as DHCP clients? Select TWO.
A. BRI interface
B. ADSL interface
C. ATM subinterface
D. Ethernet interface
E. Frame Relay interface
F. DSX-1 or G. 703 interface
Answer: CD
certification HP HP0-144 HP0-144 HP0-144 HP0-144
Le test HP HP0-144 est l'un très improtant dans tous les tests de Certification HP, mais c'est toujours difficile à obtenir ce Certificat. La présence de Pass4Test est pour soulager les candidats. L'équipe de Pass4Test peut vous aider à économiser le temps et l'éffort. Vous pouvez passer le test sans aucune doute sous l'aide de notre Q&A.
没有评论:
发表评论